semiatic

Frigidaire dishwasher error codes

7 codes that Frigidaire publishes for its dishwashers, each with what it means, the likely cause, what you can safely check and when to call a technician. Tap your code:

What people ask

What does CL mean on a Frigidaire dishwasher? Frigidaire: “Error code CL or Cd indicates that the door has not been successfully closed and latched.” It is not a broken part, and nothing needs resetting: “Check and make sure the door is complete closed and the error code will turn off.” Only if the door will not close or latch does Frigidaire’s guide say “service should be contact to check and repair.” On this page: CL door is open.
Sources: Frigidaire, Frigidaire owner support — Dishwasher Error Code CL or Cd: Dishwasher door is open Checked 2026-10-13. · Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-10-13.

What does i20 mean on a Frigidaire dishwasher? Frigidaire: “Error Code i20 indicates that the dishwasher is not draining properly.” Its checks, in order: on a new installation, “The knockout plug in disposer has been removed”; the drain hose is not blocked, pinched or restricted and rises at least 32 in (81 cm) above the floor; and the glass trap and filter are clear of food soil. On this page: i20 did not drain completely.
Source: Frigidaire, Frigidaire owner support — Dishwasher Error Code i20: Unit did not drain properly Checked 2026-10-13.

4 more: Hd / HO, PF, a number on the display, resetting a code

What does Hd or HO mean on a Frigidaire dishwasher? It is not a fault: Frigidaire says Hd or HO “indicates the unit is in the "Heat Delay" or "Heater On" mode”, a pause “to allow the dishwasher to heat the water to the optimal temperature for best performance.” The wait “normally is approximately 1 to 2 min. for each degree in temperature rise”, so water that has to climb 10 degrees holds the cycle for roughly 10 to 20 minutes, and colder incoming water means a longer wait. On this page: Hd heat delay.
Source: Frigidaire, Frigidaire owner support — Dishwasher Error Code Hd or HO: Heat delay or heater on mode activated Checked 2026-10-13.

What does PF mean on a Frigidaire dishwasher? Frigidaire: “Error code PF occurs when there is a loss of power.” To clear it, Frigidaire says pressing “the START/CANCEL button should cancel this error and a new cycle can be started”; no technician is needed for a power cut. On this page: PF power was lost.
Source: Frigidaire, Frigidaire owner support — Dishwasher Error Code PF: Loss of Power Checked 2026-10-13.

What does a number such as 1 mean on a Frigidaire dishwasher display? A number on its own is not an error code. Frigidaire’s guide lists “1-199 - Number of minutes left in a cycle” and “01-24 - Delayed option has been activated”, the delayed start that “will begin the cycle once the displayed time reaches 0.” So a 1 during a wash is the last minute of the cycle; to skip a delay, Frigidaire says “Simply cancelling this feature will start the selected cycle.”
Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-10-13.

How do you reset a Frigidaire dishwasher error code? It depends on the code. For i20 Frigidaire lists three resets: “Pressing / holding the cancel button”, “Turning power off at the breaker” or “Unplugging the dishwasher for 3 minutes”; PF clears with the START/CANCEL button, CL goes off by itself once the door is latched, and Hd or HO ends when the water is hot. A reset does not clear the cause: an i20 or i40 comes back until the drain hose, filter and sump are sorted. On this page: i20 did not drain completely · i40 clogged filter or sump.
Sources: Frigidaire, Frigidaire owner support — Dishwasher Error Code i20: Unit did not drain properly Checked 2026-10-13. · Frigidaire, Frigidaire owner support — Dishwasher Error Code PF: Loss of Power Checked 2026-10-13. · Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-10-13.

The questions are the ones people search for Frigidaire dishwasher codes; each answer comes only from the Frigidaire pages named under it.

Switch off and unplug before checking. Anything electrical, anything to do with gas, and any water leak at the mains: call a technician. Codes that need one are marked Technician.

Read this first

This page covers US (North American) models: Frigidaire dishwashers sold in the United States and Canada. Frigidaire’s own guide to its dishwasher codes is short, and half of it is the display telling you what the dishwasher is doing rather than reporting a fault: CL, Hd and PF (and LOC, which only shows that the door is locked). The two real faults it lists are both about water getting out: i20 (did not drain) and i40 (clogged filter or sump). A number from 1 to 199 is simply the minutes left, and 01 to 24 counts down a delayed start. Models differ, so check your owner’s manual. AEG, Electrolux and Zanussi dishwashers sold in the UK use their own i-codes: see their page.

i20 Did not drain completely

What it means
The dishwasher did not finish draining.
Likely cause
The disposer knockout plug still in place, a blocked, pinched or restricted drain hose, a drain hose too low, or food soil in the filters and sump.
What you can safely check

Switch off and unplug before checking.

  • New installation: make sure the knockout plug in the disposer has been removed.
  • Check the drain hose is not blocked, pinched or restricted, and that it reaches at least 32 in (81 cm) above the floor.
  • Clean the filters and sump.
  • Reset by pressing Cancel, switching off at the breaker, or unplugging for 3 minutes.
When to call a technician
If it still does not drain, contact Frigidaire to book a technician.

Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-09-29.

i40 Clogged filter or sump

What it means
Food soil has built up in the sump.
Likely cause
A dirty filter and glass trap.
What you can safely check

Switch off and unplug before checking.

  • Clean the glass trap and filter, then run the dishwasher again.
When to call a technician
If the code continues, contact Frigidaire to book a technician.

Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-09-29.

CL Cd Door is open

What it means
The door has not closed and latched.
Likely cause
The door is not shut, or not latching.
What you can safely check

Switch off and unplug before checking.

  • Close the door firmly until it latches: the code goes off.
When to call a technician
If the door will not close or latch, book a technician.

Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-09-29.

Hd HO Heat delay

What it means
The dishwasher is in Heat Delay or Heater On mode, warming the water before it carries on. Frigidaire says it takes roughly 1 to 2 minutes for each degree the water must rise, so colder water means a longer wait.
Likely cause
Incoming water cooler than the dishwasher needs.
What you can safely check

Switch off and unplug before checking.

  • Let it finish heating.
When to call a technician
No technician is needed: this is normal.

Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-09-29.

PF Power was lost

What it means
The dishwasher lost power.
Likely cause
A power cut.
What you can safely check

Switch off and unplug before checking.

  • Press Start/Cancel to clear it, then start a new cycle.
When to call a technician
No technician is needed for a power cut.

Source: Frigidaire, Frigidaire owner support — Dishwasher Error Codes and Alarms Guide Checked 2026-09-29.

A code that is not listed here

Frigidaire says that for a message code not in its guide, you should look in your owner’s manual; if an error keeps coming back, contact Frigidaire.

We list only codes the source below states. If your code is not here, it may belong to a model the source does not cover: your model’s manual is the authority.

Related pages

Source

Every code on this page comes from this page, published by Frigidaire and read on the date shown. Meanings are written in our own words; nothing is taken from other makes, other models or third-party code sites.

Made with AI tools. · Privacy