Shark: Error 6, bumper error
The front bumper, or the bumper around the LiDAR module on top, may be jammed or blocked.
Applies to: Shark RV2800 series. What you notice: error number 6. This number is SharkNinja’s; on another maker’s robot the same number means something else.
What SharkNinja says to do
- Take the robot off the base and hold POWER for 3 seconds to switch it off.
- Clear debris from the top, sides and underside of the front bumper, then press the bumper in at the front right, front left, front middle and from the top: it should spring in and out freely everywhere.
- Look into the LiDAR module on top for hair or debris; SharkNinja suggests turning it 10 times clockwise with a cotton swab to free it.
- Slide the robot onto the base to switch it back on and press VACUUM.
- If the error keeps returning, contact Shark support with your model and this error code.
Source
SharkNinja’s own support pages or manual, read on the date shown.
- SharkNinja Support: RV2800 Series Error Codes - Bumper Error #6 — RV2800 series. support.sharkninja.com Checked 2026-09-29.
- SharkNinja Support: RV2800 Series Shark® POWERDETECT™ NeverTouch Base Robot Vacuum - Robot Error Codes — RV2800 series (RV2800ZE, RV2820ZE, RV2800YE, RV2820YE, UR2860YS, AV2810YS and the other listed models). support.sharkninja.com Checked 2026-09-29.
The same number on other robots
Listed apart on purpose: each is that maker’s own code, not this one.