semiatic

Smeg error codes

25 codes that Smeg publishes for an oven and a hob, each quoted from the maker’s own manual or support page and explained on its appliance’s page. Pick the appliance, or type the code from the display: only Smeg codes are searched here.

Every Smeg appliance we cover

ApplianceCodesSource
Smeg oven10 codesSmeg, 1 document
Smeg hob15 codesSmeg, 3 documents

Smeg oven error codes

10 codes from Smeg. 10 of them are marked for a technician; for the rest the page gives the checks the maker lets an owner do. Tap a code for its meaning:

Smeg hob error codes

15 codes from Smeg. 11 of them are marked for a service engineer; for the rest the page gives the checks the maker lets an owner do. Tap a code for its meaning:

The same Smeg code on more than one appliance

Smeg uses these codes on more than one of its appliances. Read the one for your machine: the cause and what you can check are the maker’s for that appliance, and they can differ even where the fault sounds alike.

  • E2: oven — e code: engineer’s visit; hob — zone overheating.

Switch off and unplug before checking. Anything electrical, anything to do with gas, and any water leak at the mains: call a technician. Hob: do only the checks the maker gives for that code. A built-in hob is wired in, so where a maker says to cut the power, switch it off at the fuse box (circuit breaker); never lift the hob out of the worktop or open it. The electrical connection is for the installer or a qualified electrician, and anything past the maker’s own checks is for the maker’s service engineer. Two Smeg models can use different codes: your model’s manual is the authority.

Sources

Every Smeg code on this site comes from these pages, published by Smeg and read on the date shown.

Made with AI tools. · Privacy