semiatic

Bradford White gas water heater status light: 1 flash every second

ICON control by Resideo, V2: Not an error: the main valve is open and the main burner is lit, heating the water.
ICON control by SIT: Not an error: the main valve is open and the main burner is lit. Not a fault.

If you smell gas

Stop: do not relight or troubleshoot anything. Bradford White’s own words (first page of both Installation and Operation Manuals, 238-51007-00R and the Ultra Low NOx 238-53393-00K):

  • DO NOT try to light any appliance.
  • DO NOT touch any electrical switch.
  • DO NOT use any phone in your building.
  • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
  • If you cannot reach your gas supplier, call the fire department.

Calling from a neighbor’s phone means leaving the building first.

Our drawing of a gas control valve: one flash every second, over and over.

Bradford White’s manual has 2 gas controls with a table for this pattern, and they do not all mean the same thing: the full wording for each is below.

What you see: one flash every second, over and over. Applies to: Bradford White residential gas-fired tank water heaters with the ICON System electronic gas control.

What it means, by gas control

ICON control by Resideo, V2

The manual’s wording: “One flash every second (LED green)”.

Not an error: the main valve is open and the main burner is lit, heating the water. The control shuts the burner off by itself when the water reaches the set temperature.

Not a fault.

Source: Gas-Fired Water Heater Installation and Operation Manual (238-51007-00R, REV 07/26), “Troubleshooting — ICON System Electronic Gas Control” (Resideo V1, Resideo V2, SIT).

ICON control by SIT

The manual’s wording: “One flash every second”.

Not an error: the main valve is open and the main burner is lit. The thermostat is calling for heat and the heater is in a heating cycle.

Not a fault.

Source: Gas-Fired Water Heater Installation and Operation Manual (238-51007-00R, REV 07/26), “Troubleshooting — ICON System Electronic Gas Control” (Resideo V1, Resideo V2, SIT).

What Bradford White tells the owner to do

Bradford White’s manual gives the owner no step of their own for this code: it is normal operation.

semiatic gives no repair instructions of its own. The steps above are only the ones Bradford White addresses to the owner in its manual.

When to call a qualified service agency

This pattern is normal operation. If the light shows a fault code instead, or you have no hot water with the light normal and the knob set correctly:

Bradford White’s manual: “CAUTION: For your safety, do not attempt repair of combination gas control, burners or gas piping. Refer repairs to a qualified service technician.” Its FAQ adds: “If you are experiencing operating issues with your water heater, please contact a plumbing professional.”

Source

Bradford White’s own manuals, read on the date shown.

Other Bradford White status lights