semiatic

Rheem gas water heater status light: 4 red blinks every 3 seconds

The high water temperature limit has tripped: the water got hotter than the control’s safety limit, and the heater has shut down.

If you smell gas

Stop: do not relight or troubleshoot anything. Rheem’s own words (first page of both Use & Care Manuals, AP23060 and the Low NOx AP23698):

  • Do not try to light any appliance.
  • Do not touch any electrical switch; do not use any phone in your building.
  • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
  • If you cannot reach your gas supplier, call the fire department.
  • Do not return to your home until authorized by the gas supplier or fire department.

Calling from a neighbor’s phone means leaving the building first.

×4, pause
Our drawing of a gas control valve: 4 flashes, then a pause, repeating.

What you see: 4 flashes, then a pause, repeating. Applies to: Rheem residential atmospheric gas water heaters, 29 to 60 gallons, natural or LP gas — the manual linked from the Rheem Performance atmospheric XG40T06EC36U1 product page.

What it means

The manual’s wording: “Four (4) blinks every three (3) seconds — red; the label calls it High Temperature Shutdown” — Rheem FVIR atmospheric models (AP23060).

The high water temperature limit has tripped: the water got hotter than the control’s safety limit, and the heater has shut down.

Source: Use & Care Manual with Installation Instructions — Water Heaters, Residential Gas, FVIR Certified (AP23060 Rev 01), “Combination Gas Control, Status Light Troubleshooting”.

What Rheem tells the owner to do

Rheem’s manual gives the owner no step of their own for this code: call for service.

Rheem’s chart gives no owner step for this code: it says to see “If You Need Service”.

semiatic gives no repair instructions of its own. The steps above are only the ones Rheem addresses to the owner in its manual.

When to call a qualified service agency

Rheem’s manual: “CAUTION: For your safety DO NOT attempt repair of gas piping, Combination Gas Control (Thermostat), burners, vent connectors or other safety devices. Refer repairs to qualified service personnel.” For service it says to contact your installer, plumbing contractor or previously agreed upon service agency first, then Rheem’s national service department on 1-800-432-8373 with the model and serial number from the rating plate.

Source

Rheem’s own manuals, read on the date shown.

The same pattern on other brands

The same count on another maker’s gas control can mean something else.

Other Rheem status lights